downloads (updated November 22, 2009) User manual for the GSA software User manual for the B 737 chronometer User manual for the I/O module (without USB - english) User manual for the I/O module(USB version - english) Brochure Overhead panel gauges B737 Brochure B737 Chronometer Brochure Collins Style radio set Brochure turboprop engine cluster (KA350) Brochure Geneal Aviation Digital Clock Brochure Cessna style Engine Cluster Brochure DME display Our software runs in fact through a serial port which is virtually created by a USB port. To do this, you need to install a VCP driver from the chip manufacturer. Virtual COM port (VCP) drivers cause the USB device to appear as an additional COM port available to the PC. Our application software accesses the USB device in the same way as it would access a standard COM port. Vista users had some problems with the existing drivers. Hence we advice to check on the page link below to download the appropriate driver according to your PC operating system. go to the manufacture download page You will need this driver to have the interface connected to the PC. GSA software full version 7.0.5 software to make the gauges work. This is the primary setup package, including all the drivers for the USB port as well as the cabinet file. If you are a first time user, this is the file to download. released November 22, 2009   GSA software exe file version 7.0.6 For customers who have already installed the gauges, but want to upgrade the software. This is only the executable file and the config file. Unzip the file and paste the exe file in your flight illusion folder. released february 12, 2009 You will need to copy both the exe and the cgf file, hence overwriting your own config file. This means that if you want to use version 7,0 then you will have to reconfigure all your gauges and I/O module inputs and outputs. Unless you have then new NAV gauges   GSA software for X-plane version 7.1.0 This is version 7.1.0 for X-plane and it is fully functional. Most of the Gauges, Radio’s, etc. are implemented now. Also the X-Plane data-ins and data-outs are seriously extended. Apart from driving the gauges, the program includes tools for adding, modifying and or testing the various X-Plane parameters. This program also includes the function to create own (special) gauge plates. released November 22, 2009   GSA software for X-plane version 7.1.1 For customers who have already installed the gauges, but want to upgrade the software. This is only the executable file and the config file. Unzip the file and paste the exe file in your flight illusion folder. released february 12, 2009 You will need to copy both the exe and the cgf file, hence overwriting your own config file. Engine cluster software (full package) Unzip the file on your PC and run the setup.   Engine cluster FSX patch. unzip file (350 kb) and replace your exe-file with the new one.