The yaw damper gauge reflects the inputs given by the autpilot to the rudder trim. These inputs are not fed back to the rudder pedals, which is why there is an indicator.
The yaw damper system can move the rudder a maximum of 2 degrees (-1/200), 3 deg (-3/4/500), 2 deg (NG flap up), 3 deg (NG flap down), either side of the trimmed position.
height 50 mm
width 70 mm
depth 42 mm
weight 80 gr
mounting 4 screws
power= 5v/12v (included within the flatcable, so only a single connection to the interface is required!)
lights= 2 LED
type daisy chain, 10 pin connector on flat cable (10 wires flatcable)
You will need the GSA-055 (central interface) to connect the gauge to the computer.
Only logged in customers who have purchased this product may leave a review.