Create your own gauge by customizing the faceplate and configure it accordingly. The GSA-056 is based on a large single needle gauge with no faceplate. There is a dual tape glued on the faceplate holder with a protection sheet on the top side.
Customers create their own faceplate according to the type of cockpit that they are building. The needle can then be calibrated in the software. Any Flight Simulated gauges that has an offset readable by FSUIPC could be used for the gaugeand the faceplate.
The GSA-056 comes with an aluminium black coated bezel, a large needle and a persplex transparent plate.
height 83 mm
width 83 mm
depth 27 mm
weight 200 gr
mounting 4 screws
power= 5v/12v (included within the flatcable, so only a single connection to the interface is required!)
lights= 2 LED
type daisy chain, 10 pin connector on flat cable (10 wires flatcable)
You will need the GSA-055 (central interface) to connect the gauge to the computer.
Only logged in customers who have purchased this product may leave a review.